New Generation 2 wheel bearing kit

Draper Tools have conceived a kit to work perfectly with GEN2 bearings

New Generation 2 wheel bearing kit
Draper Tools has developed a specialist Generation 2 installation kit.

The unique design of “GEN2” wheel bearings, which contain built-in sensor rings used by ABS, traction control and vehicle stability systems are being used in increasingly more Audi, Ford, Land Rover, Mazda, Seat, Skoda, VW and Volvo models.

If Generation 2 wheel bearings are pressed into place as a conventional bearing, the force applied causes stress through the bearing, damage to the sensors rings and rapid deterioration.

The Generation 2 Kit is designed to correctly distribute the pressing forces through the outer bearing ring alleviating the potential for bearing and sensor failure, whilst ensuring the special retaining clip ring is correctly located.

All this while allowing the suspension leg to remain in-situ, saving valuable workshop time and space.

Included in the kit is a full selection of specialist adaptor plates, connection rods and high strength thrust bearing pullers, enabling a wide range of GEN2 bearings to be safely and efficiently removed or replaced.

This new Draper expert Generation 2 master bearing kit is an essential for the professional workshop, helping to make light work of safely removing or installing GEN2 bearings.

To find out more and see the full range of automotive tools available from Draper Tools, click ‘more details’ below.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>


The reCAPTCHA verification period has expired. Please reload the page.

Have your say!

0 0

Lost Password

Please enter your username or email address. You will receive a link to create a new password via email.