CV boot clamp pliers from Laser Tools

Get the torque settings specified by the manufacturer with these easy-to-use CV boot clamp pliers

CV boot clamp pliers from Laser Tools

The CV boot clamp pliers from Laser Tools is a robust, strongly manufactured tool that features a 3/8″ drive and is specifically designed to be used with a torque wrench.

The clamp pliers are fitted with two-way jaws, set at 90° to each other, which greatly assists in gaining access to the clamp in the busy suspension/driveshaft areas.

The smooth action of the pliers makes it easy to ensure compliance with the torque settings specified by the manufacturer; this figure is typically between 23 and 30 Nm, depending on the vehicle.

These pliers are typically priced at £88.90 + VAT from Laser Tools stockists but always check for the best prices and special offers.

A Laser Tools spokesperson said: “For drive shaft and constant velocity joint rubber boots, traditionally the securing clamps have simply been compressed with clamp pliers.

“But on modern vehicles the high-strength stainless steel clamps need much more force to compress them and secure the boot.

“For this reason manufacturers (VAG, Vauxhall/Opel, Ford and others) now specify a torque figure that the boot clamps have to be tightened to.

“If the clamps are not tightened to the specified torque figure, the boots could leak.”

For further information, select ‘more details’ below.

Home Page Forums CV boot clamp pliers from Laser Tools

This topic contains 0 replies, has 1 voice, and was last updated by  Mike Ruff, GW editor 1 week ago.

You must be logged in to reply to this topic.

Have your say!

0 0

Lost Password

Please enter your username or email address. You will receive a link to create a new password via email.