First Line reveals PSA thermostat specification changes

OE production issue caused overheating related problems

First Line reveals PSA thermostat specification changes

Known issues caused by the specification of the thermostat and thermostat housing installed during their original production on multiple PSA applications – Citroën C3, C4, DS3, Peugeot 207, 208, 2008, 308, 3008, 508, 5008, RCZ, Partner, BMW MINI – 1.4i/1.6i 2006 onwards – led to an increasing number of premature failures.

Many owners complaining of overheating related problems and reporting symptoms such as an irregular temperature gauge, erratic engine running, radiator fan run-on or poor heater function.

As a result, PSA has modified the design of the thermostat housing several times in an attempt to correct the issues.

The modified versions have several enhancements including reinforced connections and a more robust structure to minimise the potential of warping or fracturing.

The lower sensor has been moved to accommodate a new electronically operated thermostat, which replaces the wax version used in the original design.

Technicians need to be aware that these modifications have meant that there is a visual difference between the new and old designs.

However, providing the factor has supplied what is specified in the First Line catalogue, rather than what ‘through experience’ they consider to be the ‘correct’ replacement, then they can have complete confidence that it is correct for the application and therefore okay to install, even if it looks different.

In particular, the references that have been re-specified include First Line part number FTK422.

Originally this had a single four-pin sensor on top of the housing, but this has been modified by changing it to two, two-pin sensors, one remaining at the top and the second being moved to the lower side.

As this original single sensor has been split into two, a new wiring harness is required, which is only available from the OE supplier.

The OE design of the housing was then modified again, this time necessitated by the replacement of the wax thermostat by a new electronically controlled version and to accommodate the change, the lower sensor was moved round to the back of the housing.

Therefore, FTK422 was subsequently superseded to FTK454 following these modifications.

Other supersessions include FTK102 and FTK396, which have been superseded to FTK481 and FTK477 respectively. The housing for these two references already had the two, two-pin sensors and therefore only underwent the thermostat modification and lower sensor relocation.

Despite these relatively small changes in the overall scheme of a vehicle, without foreknowledge, these differences can cause confusion for technicians tasked with undertaking service and repair work associated with these components.

However, one of the main benefits of fitting First Line products is that they can be sure that the component they are installing follows the latest OE specification, whether it looks familiar or not.

In order to follow best practice, First Line recommends that when replacing any of these thermostats/thermostat housings, it is advised that the engine ECU software is checked and re-programmed before any components are replaced to ensure it is set to reflect the latest version.

For more information about First Line Ltd, call 01869 248484 or select ‘more details’ below.

Have your say!

2 1

Lost Password

Please enter your username or email address. You will receive a link to create a new password via email.